Shopping Cart
Your Cart is Empty
Quantity:
Subtotal
Taxes
Shipping
Total
There was an error with PayPalClick here to try again
CelebrateThank you for your business!You should be receiving an order confirmation from Paypal shortly.Exit Shopping Cart

Elite Appliance Service

S. Cashua Dr. Florence SC 29501 US

Elite Appliance Service

Exceptional Service, Experience You Can Trust

My Blog

Blog

Calibrating oven temperatue

Posted on May 3, 2012 at 8:22 PM
How do I adjust the oven temperature on my range?
 
There have been numerous oven control systems used over the years. The following instructions describe various methods that might be employed to correct such a condition.
 
In almost all cases if the temperature reading is more than 35°F out, some part of the control system will need to be repaired. Usually adjustment will not provide an adequate solution to the condition and may even make it worse.
 
Before attempting any kind of adjustment on a hydraulic oven control, make sure the thermostat's sensor bulb is properly mounted in the oven cavity and not touching the oven wall or metal rack. The sensor bulbs are held about 1/2" away from the oven wall by a small metal clip.
 
 
 
 
 
 
Dial type control
 
Some models have the calibration adjustment on the underside of the knob itself. On this type of arrangement, the loosening of the dial plate and moving it one way or the other will change the temperature reading on the dial once reinstalled.
 
 
 
 
 
Other control designs have the temperature calibration screw down the center of the shaft. These usually require a special small screwdriver to access it. See below for a link to a detailed calibration method for one brand of oven thermostat.
 
 
 
 
Electronic Control Calibration
 
 
The following procedures are designed to provide an general idea how calibration adjustment of the oven temperature display on many electronically controlled (ERC/EOC) ranges and ovens is done. The actual procedures vary from model to model so check your owner's manual.
 
If the temperature is out more than 35°F, the oven sensor or the electronic control may need to be replaced to correct the inaccuracy.
 
 General
 
  1. Press BAKE

  2. Select a temperature of 550

  3. Quickly (within 5-seconds of setting 550) press and hold the BAKE button approximately 5-15 seconds until "00" or the previously entered temperature adjustment is displayed.

    Pressing longer could cause an F0, F1 or F7 error to be displayed.

  4. Press the UP/DOWN arrow button or turn the set knob to change the oven temperature in 5° increments to a maximum of +/- 35°

  5. Press the CLEAR or OFF button to return to normal operation.


ExceptionsFor Frigidaire built "Trimline Easy-Set 1" dial type E.O.C.
  1. With the Oven Control Dial set to OFF, press and hold the START pad for 30 seconds, (until a single "beep" is heard).

  2. Within 5 seconds, turn the oven control dial to either the BROIL HI, to increase, or BROIL LO, to decrease the oven temperature. Maximum adjustment will be 35°F up or down from the factory pre-set point.

  3. The oven temperature can now be adjusted up or down, in 5°F increments, by pressing the START pad. Adjust until the desired amount of offset is reach. This offset will be indicated by a flashing L.E.D.

A flashing "OVEN" L.E.D. indicates a positive offset. A flashing "LOCK" L.E.D. indicates a negative offset. They will flash once for each 5°F of offset it has been programmed for. After the flashing sequence, it will pause and then repeat the sequence.Example: If the "OVEN" L.E.D. flashes three times and then a pause, the offset is +15°F. If no "OVEN" or "LOCK" L.E.D. is flashing, the E.O.C. has the original factory preset. 
For some General Electric ranges
 
  1. Press the BAKE and BROIL HI/LO pads at the same time for 3 seconds until the display shows SF.

  2. Press the BAKE pad. A two digit number shows in the display. The oven temperature can be adjusted up to +/- 35°F.

  3. Press the INCREASE pad to increase and the DECREASE pad to decrease the temperature in 1 degree increments.

  4. When you have made the adjustment, press the START pad to go back to the time of day display.

The above procedure will not affect the broil or clean temperatures.
Some GE models with temp. knob to the right of display
  1. Press and hold the two hour arrow buttons for 5 sec.

  2. Then use the arrows buttons to adjust temperature up or down.


Other GE models with temp. knob to the right of display
  1. Turn the temperature knob to the OFF position.

  2. Press and hold the HOUR +/- button for 5 seconds until the display changes.

  3. Before display changes back, press the HOUR +/- button again to increase or decrease the temperature in 5 degree increments.

    If the oven adjustment is set cooler than the factory setting, a minus sign (-) and the offset temperature will appear in the display.

  4. Wait several seconds for the control to automatically set and return to its previous setting.


Some GE models between 1980 - 1993
  1. Set bake to over 500

  2. Press and hold the bake button (~5 sec.) until display changes.

  3. Then use the knob or up/down arrows buttons to adjust temperature.


For some Whirlpool/KitchenAid/Kenmore ranges and ovens
  1. Press BAKE button for 5 seconds. The default or a previously entered temperature offset will show.

  2. Press the TEMP 'up' arrow to increase the temperature in 10°F or 5°C increments*.

  3. Press the TEMP 'down' arrow to decrease the temperature in 10°F or 5°C increments*.

  4. Press START to save the temp. adjustment.

*A maximum offset adjustment of ±30°F or ±15°C is possible.

(To switch between Fahrenheit to Celsius, try pressing and holding the "broil" button for 5 seconds).

   

Categories: DIY Tips

Post a Comment

Oops!

Oops, you forgot something.

Oops!

The words you entered did not match the given text. Please try again.

43 Comments

Reply tv installation
8:35 AM on January 6, 2013 
Electronic control calibration is very important to deal with oven temperature. I'm very glad to learn proper learning lesson of oven temperature and will look forward for interesting lessons. Thanks.
Reply Titus Neuman
10:48 AM on January 30, 2013 
Wow what an informative post at all! I am so pleased top read this content. Here you gave huge information to control oven temperature and I hope this will be helpful for us all. Thanks for this allocation.
Reply maid service seattle
7:18 AM on April 1, 2013 
So true of you while pointing out the warmth and depth about "Appliance service" I am going to apply all tips that you have mentioned in your post, they are really helpful. Regards.
Reply replica rolex
7:46 AM on July 4, 2013 
There have been numerous oven control systems used over the years. The following instructions describe various methods that might be employed to correct such a condition.
Reply fake watches sale
4:04 AM on July 10, 2013 
tv installation says...
Electronic control calibration is very important to deal with oven temperature. I'm very glad to learn proper learning lesson of oven temperature and will look forward for interesting lessons. Thanks.

A look at appeared to be produced in a tiny variation with fifty-one types around 2007.
Reply Nike Free Run 3
2:58 AM on July 20, 2013 
I seriously enjoy your posts. Thanks.
Reply led china
5:05 PM on August 31, 2013 
I was slightly apprehensive about going in with a rucksack full of leaflets and a shirt with the company name emblazoned across it's front (as we weren't actually exhibiting at the show), and half expected to be searched and told to clear off.
Reply Interface Devices
10:10 AM on January 31, 2014 
Electronic control calibration should be properly done and electronic counter must show all the values in centigrade,Celsius and Fahrenheit accurately.
Reply where to find storage auction listings
10:29 AM on March 3, 2014 
I am very happy with you. Thankx for more info.
Reply Wholesale Lingerie
8:02 AM on September 2, 2014 
Wholesale Sexy Lingerie,High Quality!Low Price! Wholesale Leggings,Plus Size Corsets,Wholesale Halloween Costumes From China Suppliers LingeriePark.Wholesale Only,No Retail!
Reply swiss watch sale
8:57 PM on January 6, 2015 
Good article and straight to the point. I am not sure if this is really the best place to ask but do you folks have any ideea where to hire some professional writers? Thank you :)
Reply profil
2:56 PM on April 17, 2015 
because of this high quality information and know how less hazardous for the toddler hundred % can create you relating to a lot of our defense additionally, the good quality of done
Reply Bane Long Coat Instylejackets
9:47 AM on April 11, 2017 
I make a great deal of these cookies as treats for family and friends around the occasions, yet it's anything but difficult to over-heat them, so it's vital the broiler's temperature be set just so.
Reply Lily Byles
12:30 AM on July 2, 2017 
Reply Lipozene
9:30 AM on August 25, 2017 
The techniques with the help of which the people can calibrate the temperature in their oven are mentioned. The temperature is set by the people in order to run the oven according to their requirements.
Reply Newt Scamander Jacket
7:07 AM on May 2, 2018 
Excellent and decent post. It is brilliant blog. I like the way you express information to us. Thanks for such post and please keep it up.
Reply Cableinternet-deals
11:20 AM on June 1, 2018 
What may you recommend about your publish that you simply made some days ago...
Reply smith
3:43 PM on June 17, 2018 
Good post, love to read this info
Reply writing essays services
2:21 PM on June 18, 2018 
Very lovely blog.Behind everything there is a reality hidden and good essay writing services skills help you to understand such hidden written secrets of life.Thanks.
Reply Richard Gordon
9:44 PM on June 19, 2018 
Good post